LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> 5 Sport, Automatic Trans >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> On-Board Diagnostic [Air Bag System - Two-Step Deployment Control System) >> DTC B104B, B104E, B1051, U2017 [Two-Step Deployment Control System] >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

Step INSPECTION Action
1 INSPECT DRIVER-SIDE SIDE AIR BAG SENSOR NO.1 CONNECTOR 
WARNING:
  • Handling the component parts improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings/cautions and the workshop manual before handling the air bag system components.

    (See AIR BAG SYSTEM SERVICE WARNINGS .)

    (See AIR BAG SYSTEM SERVICE CAUTIONS .)

  • Switch the ignition to off.
  • Disconnect the negative battery cable and wait for 1 min or more  .
  • Remove the driver-side B-pillar lower trim. (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  • Disconnect the driver-side side air bag sensor No.1 connector. (See SIDE AIR BAG SENSOR NO. 1 REMOVAL/INSTALLATION .)
  • Inspect the driver-side side air bag sensor No.1 connector. (Corrosion, damage, and disconnected pins)
  • Is there any malfunction of the driver-side side air bag sensor No.1 connector?
 Yes Replace the driver-side side air bag sensor No.1 wiring harness.
No Go to the next step.
2 INSPECT WIRING HARNESS BETWEEN SAS CONTROL MODULE AND DRIVER-SIDE SIDE AIR BAG SENSOR NO.1 
NOTE:
  • Inspect for continuity while shaking the wiring harness between the SAS control module and driver-side side air bag sensor No.1.
  • Is the wiring harness normal?
 Yes Go to the next step.
No Replace the wiring harness between the SAS control module and the driver-side side air bag sensor No.1.
3 INSPECT THE WIRING HARNESS BETWEEN THE SAS CONTROL MODULE AND DRIVER-SIDE SIDE AIR BAG SENSOR NO.1 FOR A SHORT CIRCUIT TO THE POWER SUPPLY 
  • Connect the negative battery cable.
  • Switch the ignition to ON with SAS control module connector and driver-side side air bag sensor No.1 connector disconnected.
  • Measure the voltage of SAS control module connector terminals 2O and 2S of SAS control module harness side connector.
NOTE:
  • Measure the voltage while shaking the wiring harness between the SAS control module and driver-side side air bag sensor No.1.
  • Is the voltage measured?
 Yes Replace the wiring harness between the SAS control module and the driver-side side air bag sensor No.1.
No Replace the driver-side side air bag sensor No.1, then go to the next step.
(See SIDE AIR BAG SENSOR NO. 1 REMOVAL/INSTALLATION .)
4 PERFORM SAS CONTROL MODULE DTC INSPECTION  Yes Replace the SAS control module.
(See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals