| DETECTION CONDITION |
- P0457:00 indicates that the initial vacuum could not be achieved after a refueling event and the purge vapor flow is excessive (gross leak).
Diagnostic support note
- This is an intermittent monitor (EVAP system).
- A check cap light will be illuminated after a malfunction has been detected on one driving cycle. The check cap light will be extinguished after the monitor has run without a malfunction (same or subsequent drive cycle).
- The MIL will be illuminated after a malfunction has been detected on three consecutive driving cycles. The MIL will be extinguished after three consecutive driving cycles where the monitor was run without a malfunction.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- The DTC is stored in the PCM memory.
|