| DETECTION CONDITION |
- The actual idle speed is lower than expected by specified for 8.4 s
when the target idle speed correction value for cold start is above 0 rpm
.
NOTE:
- If intake air temperature is below -10 °C {14 °F}
, the PCM cancels diagnosis of P050A:00.
Diagnostic support note
- This is a continuous monitor (cold start emission reduction strategy monitoring).
- The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode2)/Snapshot data is not available.
- The DTC is stored in the PCM memory.
|