| DETECTION CONDITION |
- If an error in the wheel speed signal from the DSC HU/CM is detected by CAN when the following conditions are met:
MONITORING CONDITIONS
- Neutral switch and CPP switch: OFF (MTX)
- Shift range: except P, N or R position (ATX)
- Absolute load: above 40 %
- Engine speed: above 2,000 rpm
- Brake switch: OFF
- Vehicle speed: below 3.76 km/h {2.34 mph}
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- The DTC is stored in the PCM memory.
|