HO2S Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine on).
- Warm up the engine to normal operating temperature.
- Access the following PIDs using the M-MDS. (See
ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0]
).
- VSS (Vehicle speed)
- RPM (Engine speed)
- O2S12 (HO2S output voltage)
- Drive the vehicle and decelerate the engine speed by releasing the accelerator pedal fully when the engine speed is 3,000 rpm or more
.
- Verify that the HO2S output voltage (PID: O2S12) is 0.3 V or less
while decelerating as shown in the figure.