Load compensation inspection
- Start the engine and let it idle.
- Connect the M-MDS to the DLC-2.
- Verify that DTC P0506:00 or P0507:00 is not displayed. (See
ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0]
).
- If DTC P0506:00 or P0507:00 is displayed, perform the DTC inspection. (See DTC P0506:00 [SKYACTIV-G 2.0] ). (See DTC P0507:00 [SKYACTIV-G 2.0] ).
- Select the RPM PID.NOTE:
- Excludes temporary idle speed drop just after the loads are turned on.
- Verify that the engine speed is within specification under each load condition.
- If the load condition is not as specified, inspect the following:
- A/C switch and related wiring harness system (A/C request signal is always on or off) (See NO.23 A/C DOES NOT WORK SUFFICIENTLY ). (See NO.24 A/C IS ALWAYS ON OR A/C COMPRESSOR RUNS CONTINUOUSLY ).
- Electrical load
- Charging system (See BATTERY INSPECTION [SKYACTIV-G 2.0] ). (See GENERATOR INSPECTION [SKYACTIV-G 2.0] ).
Idle-up speed (MTX: Neutral position, ATX: P, N position)
No load: 500-600 rpm (MTX), 550-650 rpm (ATX)
A/C on: 650-800 rpm
Electrical loads on: 600-750 rpm
- If the load condition is not as specified, inspect the following:
RELATED PIDs DESCRIPTION
| Monitor item (Definition) | Unit/Condition | Condition/Specification (Reference) |
|---|---|---|
| RPM | RPM |
|