LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2014 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (On-Board Diagnostic - Front Body Control Module) >> DTC B1088 88: Lin Communication Error >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1088:88 (FRONT BODY CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step Inspection Action
1 VERIFY FRONT BODY CONTROL MODULE (FBCM) DTCs AGAIN 
Yes LIN communication line can be considered the cause.
  • Refer to the wiring diagram and verify whether or not there is a common connector between auto light sensor/rain sensor terminal A and front body control module (FBCM) terminal 2G.

    If there is a common connector: 

    • Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a malfunction.
    • Repair or replace the malfunctioning part.

    If there is no common connector: 

    • Repair or replace the wiring harness.
  • Go to the next step.
No Go to Step 3.
2 VERIFY THAT REPAIRS HAVE BEEN COMPLETED 
Yes Repeat the inspection from Step 1.

Go to the next step.
No Go to the next step.
3 VERIFY IF OTHER DTCs DISPLAYED 
  • Are any other DTCs displayed?
Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)] .)
No DTC troubleshooting completed.