| DETECTION CONDITION |
- The PCM compares the number of A/F sensor and HO2S inversions for a predetermined time. The PCM monitors the HO2S inversion counts when the following conditions are met. The PCM detects inversion ratio. If the inversion ratio is below specification, the PCM determine that the catalyst system has deteriorated.
- The A/F sensor inversion counts is as prescribed when the following monitoring conditions are met:
- The accumulated occurrence time of the following monitoring conditions has exceeded the prescribed time limit:
MONITORING CONDITIONS
- Calculated TWC temperature: above 400 °C {752 °F}
- Engine speed: 1, 200-3, 000 rpm
- LOAD: 16-48 %
(at engine speed of 2, 000 rpm
)
Diagnostic support note
- This is an intermittent monitor (catalyst).
- The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- The DTC is stored in the PCM memory.
|