LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2015 >> 3 SV, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> On-Board Diagnostic - Front Body Control Module (FBCM) >> DTC U0338 09: Error Light Switch Signal Received From Start Stop Unit >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

DTC U0338 09 DIAGNOSTIC PROCEDURE

Step Inspection Action
1 VERIFY FRONT BODY CONTROL MODULE (FBCM) DTCs AGAIN 
Yes Go to the next step.
No Go to Step 6.
2 VERIFY START STOP UNIT DTCs 
Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [START STOP UNIT] .)
No Go to the next step.
3 INSPECT LIGHT SWITCH 
Yes Go to the next step.
No Replace the light switch, then go to Step 5.
(See LIGHT SWITCH REMOVAL/INSTALLATION .)
4 PERFORM DTC INSPECTION AND VERIFY START STOP UNIT MALFUNCTION 
Yes Replace the start stop unit, then go to the next step.
(See START STOP UNIT REMOVAL/INSTALLATION .)
No Go to Step 6.
5 VERIFY THAT REPAIRS HAVE BEEN COMPLETED 
Yes Repeat the inspection from Step 1.

Go to the next step.
No Go to the next step.
6 VERIFY IF OTHER DTCs DISPLAYED 
  • Are any other DTCs displayed?
Yes Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [FRONT BODY CONTROL MODULE (FBCM)] .)
No DTC troubleshooting completed.