Function Inspection Using M-MDS

STEP	INSPECTION	RESULTS	ACTION
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: VERIFY IF OPERATION IS NORMAL AFTER VEHICLE COLLISION Ask customer about vehicle collision experience. Has the vehicle in for servicing been involved in a collision in which the air bag is deployed?	Yes	Explain to the customer that the DTC is recorded as a result of a vehicle collision. Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 1.
2		No	Go to the next step.
3	PURPOSE: VERIFY IF DIAGNOSTIC RESULT IS AFFECTED BY DTC RELATED TO SAS CONTROL MODULE Switch the ignition off, then ON (engine off). Perform the SAS control module DTC inspection using the M-MDS. (See DTC INSPECTION [STANDARD DEPLOYMENT CONTROL SYSTEM] .) (See DTC INSPECTION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [STANDARD DEPLOYMENT CONTROL SYSTEM] .) (See DTC TABLE [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .) Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 1.
3		No	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 1.