Function Inspection Using M-MDS

STEP	INSPECTION	RESULTS	ACTION
1	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: VERIFY IF POWER SUPPLY IS AFFECTED BY DTC RELATED TO DC-DC CONVERTER Switch the ignition off, then ON (engine off). Perform the DC-DC converter DTC inspection using the M-MDS. (See DTC INSPECTION [I-ELOOP] .) Is the PENDING CODE/DTC U3000:49 also present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC U3000:49 [I-ELOOP] .) Go to the next step.
2		No	Go to the next step.
3	PURPOSE: VERIFY IF POWER SUPPLY IS AFFECTED BY DTC RELATED TO PCM Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Is the PENDING CODE/DTC P0A12:00 also present?	Yes	Go to the applicable PENDING CODE or DTC inspection. (See DTC P0A12:00 [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) Go to the next step.
3		No	Go to the next step.
4	PURPOSE: DETERMINE IF MALFUNCTION CAUSED BY DC-DC CONVERTER Start the engine. Is illuminate the master warning light?	Yes	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 1.
4		No	Go to the TROUBLESHOOTING PROCEDURE to perform the procedure from Step 3.