Diagnostic Procedure
DTC P2107:00 (SKYACTIV-G 2.0, SKYACTIV-G 2.5) - DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED
|
Yes | Go to the next step. |
| No | Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step. | ||
| 2 | VERIFY RELATED REPAIR INFORMATION AVAILABILITY
|
Yes | Perform repair or diagnosis according to the available repair information.
|
| No | Go to the next step. | ||
| 3 | INSPECT THROTTLE BODY CONNECTOR CONDITION
|
Yes | Repair or replace the connector and/or terminals, then go to Step 6. |
| No | Go to the next step. | ||
| 4 | INSPECT PCM CONNECTOR CONDITION
|
Yes | Repair or replace the connector and/or terminals, then go to Step 6. |
| No | Go to the next step. | ||
| 5 | INSPECT THROTTLE VALVE ACTUATOR CIRCUITS FOR SHORT TO EACH OTHER
|
Yes | Refer to the
wiring diagram and verify whether or not there is a common connector between the following terminals:
If there is a common connector:
If there is no common connector:
Go to the next step. |
| No | Go to the next step. | ||
| 6 | VERIFY DTC TROUBLESHOOTING COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| 7 | VERIFY AFTER REPAIR PROCEDURE
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .) |
| No | DTC troubleshooting completed. | ||