PID/Data Monitor Table [Standard Deployment Control System]

PID/DATA MONITOR CHART

PID	Unit/Condition	Data contents	SAS control module terminal
AB_WL (Air bag system warning light status)	Lamp_Off/Lamp_On/Plant_Mode/Unknown	Air bag system warning light off: Lamp_Off Air bag system warning light on: Lamp_On Air bag system warning light status: Plant_Mode Air bag system warning light status: Unknown	3K, 3L
B_SW_P_FLT (Passenger-side buckle switch malfunction status)	NOTE: Displays in the M-MDS but it does not operate.
OCS_DTC_CLR (Seat weight sensor DTC cleared status)	NOTE: Displays in the M-MDS but it does not operate.
P_OCS_ST (Seat weight sensor status)	NOTE: Displays in the M-MDS but it does not operate.
P_WEIGHT (Seat weight sensor measured weight of passenger)	NOTE: Displays in the M-MDS but it does not operate.
RES_C_AB_D (Driver-side curtain air bag module resistance nominal)	ohm	Continuous: 0.81-6.42 ohms	1S, 1V
RES_C_AB_P (Passenger-side curtain air bag module resistance nominal)	ohm	Continuous: 0.81-6.42 ohms	1W, 1T
RES_F_AB1_D (Driver-side air bag module (inflator No. 1) resistance nominal)	ohm	Continuous: 0.99-6.42 ohms	3A, 3D
RES_F_AB1_P (Passenger-side air bag module (inflator No. 1) resistance nominal)	ohm	Continuous: 0.81-6.42 ohms	3G, 3J
RES_F_AB2_D (Driver-side air bag module (inflator No. 2) resistance nominal)	NOTE: Displays in the M-MDS but it does not operate.
RES_F_AB2_P (Passenger-side air bag module (inflator No. 2) resistance nominal)	NOTE: Displays in the M-MDS but it does not operate.
RES_PCD_BAR (Poorly connected detector bar terminals resistance nominal (all of SAS control module connectors))	ohm	Normal connected: 100 ohm or less Poor connected: 20 kilohm or more	1a, 1b, 2a, 2b, 3a, 3b
RES_S_AB_D (Driver-side side air bag module resistance nominal)	ohm	Continuous: 0.81-9.85 ohms	1A, 1D
RES_S_AB_P (Passenger-side side air bag module resistance nominal)	ohm	Continuous: 0.81-9.85 ohms	1J, 1G
RES_SB_LP_D (Driver-side lap pre-tensioner seat belt resistance nominal)	NOTE: Displays in the M-MDS but it does not operate.
RES_SB_LP_P (Passenger-side lap pre-tensioner seat belt resistance nominal)	NOTE: Displays in the M-MDS but it does not operate.
RES_SB_P_D (Driver-side pre-tensioner seat belt resistance nominal)	ohm	Continuous: 0.81-6.42 ohms	2D, 2A
RES_SB_P_P (Passenger-side pre-tensioner seat belt resistance nominal)	ohm	Continuous: 0.81-6.42 ohms	2G, 2J
SEAT_B_D (Driver-side buckle switch status)	Unbuckled/Buckled	Driver-side front seat belt fastened (Driver-side buckle switch off): Buckled Driver-side front seat belt not fastened (Driver-side buckle switch on): Unbuckled	2U
SEAT_B_P (Passenger-side buckle switch status)	NOTE: Displays in the M-MDS but it does not operate.
VPWR_IGA (SAS control module power voltage)	V	Ignition is switched ON: IG1 voltage	3C