Seat Weight Sensor Control Module Removal/Installation [Two-Step Deployment Control System]

CAUTION:

When the seat weight sensor control module is replaced with a new one, perform the seat weight sensor calibration using the M-MDS. (See SEAT WEIGHT SENSOR CALIBRATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)

Switch the ignition to off.
Disconnect the negative battery cable and wait for 1 min or more .
Remove the connector.

Fig 1: Identifying Seat Weight Sensor Control Module, Fastener And Connector
Courtesy of MAZDA MOTORS CORP.
Remove the fastener.
Remove the seat weight sensor control module.
Install in the reverse order of removal.