Engine Oil Solenoid Valve Control System Inspection

Connect the M-MDS to the DLC-2.
Perform the KOER self test. (Refer to KOEO/KOER SELF TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
Verify that DTC P06DA:00 is not displayed. (Refer to ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- If DTC P06DA:00 is displayed, perform the DTC inspection. (Refer to DTC P06DA:00 [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
Inspect the engine oil pressure. (Refer to OIL PRESSURE INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- If the engine oil pressure is not as specified, repair or replace the malfunctioning part according to the inspection results:
Access the following PCM PIDs using the M-MDS. (Refer to ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- OIL_P_SOL
- RPM
- ECT
With the engine coolant temperature at 98 °C {208 °F} , increase the engine speed to 4, 000 rpm or higher , and verify that the oil pressure gauge value changes when the data monitor item OIL_P_SOL value is changed from ON to OFF.
- If the oil pressure gauge value change cannot be verified, inspect the engine oil solenoid valve. (Perform the Engine Oil Solenoid Valve Operation Inspection.)
  (Refer to ENGINE OIL SOLENOID VALVE INSPECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)