| DETECTION CONDITION |
- Under the following conditions, turbine/input shaft speed suddenly increases 300 rpm or more
for 1, 450 ms
:
- Engine is running.
- Vehicle speed is 5 km/h {3 mph} or more
.
- There is no difference between vehicle speed signal from DSC HU/CM and output shaft speed sensor signal.
- Not shifting
- Selector lever position is D position.
- Turbine/input shaft speed is 1, 200 rpm or more
.
- Oil pressure switch pattern (1st-6th) is normal.
Diagnostic support note
- The check engine light does not illuminate.
- The automatic transaxle warning light does not illuminate.
- PENDING CODE is available.
- FREEZE FRAME DATA is not available.
- DTC is stored in the TCM memory.
|