September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Inspection Method for Switch Connectors or Wiring Harnesses
- Connect the M-MDS to the DLC-2.
- Switch the ignition to ON (engine off).
NOTE:
- If the engine starts and runs, perform the following steps during idle.
- Access PIDs for the switch you are inspecting.
- Turn the switch on manually.
- Slightly shake each connector or wiring harness vertically and horizontally while monitoring the PID.
- If PID value is unstable, inspect for poor connection.
 Courtesy of MAZDA MOTORS CORP.
|