DTC U2100-00; Start Stop Unit Configuration Not Completed: Notes
DETECTION CONDITION & POSSIBLE CAUSES
| Description |
Start stop unit configuration not completed |
| Detection condition |
- Start stop unit configuration not completed.
|
| Fail-safe function |
- Although the engine cannot be started with the ignition switched OFF (LOCK) or to ACC, if the ignition is switched ON (engine off), the engine can be started.
NOTE:
- If the start stop unit configuration is not completed, the start stop unit setting will be for an ATX vehicle.
- For MTX vehicles, if the start stop unit cannot receive the CAN signal, the engine cannot be started because the vehicle cannot be recognized as a MTX vehicle.
|
| Possible cause |
- Start stop unit configuration error
- Start stop unit malfunction
|
| System wiring diagram |
Not applicable |