LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2017 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Camshaft Position (CMP) Sensor Removal/Installation >> Intake CMP Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intake CMP Sensor

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Seal cover (See SEAL COVER REMOVAL/INSTALLATION ).
    2. Front suspension tower bar (Vehicles with front suspension tower bar) (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION ).
    3. Intake manifold (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION ).
  3. Disconnect the intake CMP sensor connector.
  4. Remove the bolt.
    Fig 1: Disconnecting Intake CMP Sensor Connector With Bolt
    G11274154Courtesy of MAZDA MOTORS CORP.
  5. Remove the intake CMP sensor.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals