Diagnostic Procedure
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY ALL SYSTEM DTCs
|
Yes | Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) ). |
| No | Go to Step 3. | ||
| 2 | VERIFY ALL SYSTEM DTCs AGAIN
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION ). |
| No | Go to the next step. | ||
| 3 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| 4 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [CONNECTIVITY MASTER UNIT] ). |
| No | DTC troubleshooting completed. | ||