DTC C0062-76: SAS Control Module System

DTC C0062:76 (DYNAMIC STABILITY CONTROL) DETECTION CONDITION AND POSSIBLE CAUSE

DTC	C0062:76	SAS Control Module System
DETECTION CONDITION		Error is detected in communication with SAS control module by CAN communication.
FAIL-SAFE FUNCTION		Refer to "DTC Table" and "Fail-safe Function Malfunction Contents". (See DTC TABLE (Dynamic Stability Control (DSC)) .)
POSSIBLE CAUSE		Poor SAS control module installation Low-G sensor malfunction in SAS control module DSC HU/Control Module malfunction
SYSTEM WIRING DIAGRAM		-

DTC C0062:76 (DYNAMIC STABILITY CONTROL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY IF SAS CONTROL MODULE IS CORRECTLY INSTALLED Verify the SAS control module installation condition. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .) Is the installation condition normal?	Yes	Go to the next step.
1		No	Install the SAS control module correctly, then go to the next step.
2	INSPECT SAS CONTROL MODULE MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the SAS control module. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC. )].) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC. )].)
2		No	Go to the next step.
3	PERFORM DSC RELATED PARTS SENSOR INITIALIZATION Perform the DSC related parts sensor initialization for the PCM using the M-MDS. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE .) Is the DSC sensor initialization completed normally?	Yes	Go to the next step.
3		No	Replace the DSC HU/Control Module, then go to the next step. (See DSC HU/Control Module REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .)
4	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See CLEARING DTC (Dynamic Stability Control (DSC)) .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/Control Module, then go to the next step. (See DSC HU/Control Module REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .)
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See DTC TABLE (Dynamic Stability Control (DSC)) .)
5		No	DTC troubleshooting completed.