Diagnostic Procedure

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE CONFIGURATION (AS-BUILT DATA USE) Perform the SAS control module configuration using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION (USING AS-BUILT DATA) [TWO-STEP DEPLOYMENT CONTROL SYSTEM] ). Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC (SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)) ). Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION (SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)) ). Are the same DTCs present?	Yes	Go to the next step.
1		No	DTC troubleshooting completed.
2	INSPECT CRASH ZONE SENSOR Verify that the driver or passenger-side crash zone sensor is correctly installed. Is the driver or passenger-side crash zone sensor correctly installed?	Yes	Go to the next step.
2		No	Correctly Install the driver or passenger-side crash zone sensor. Then go to the next step.
3	PERFORM SAS CONTROL MODULE DTC INSPECTION Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC (SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)) ). Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC INSPECTION (SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM)) ). Are the same DTCs present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] ).
3		No	DTC troubleshooting completed.