Error code 12/15/18/1A

360° VIEW MONITOR SYSTEM AIMING DIAGNOSTIC PROCEDURE

Step	Inspection	Action
1	PERFORM FRONT CAMERA AIMING Perform the front camera aiming. Was the front camera aiming procedure completed correctly?	Yes	The front camera aiming is completed. Perform the 360° view monitor system screen display verification procedure. (See 360° VIEW MONITOR SYSTEM SCREEN DISPLAY VERIFICATION PROCEDURE .)
1		No	If error code 12/15/18/1A is displayed Go to the next step. If code other than error code 12/15/18/1A is displayed Go to the procedure for the displayed error code.
2	VERIFY DTCs Perform the DTC inspection. (See DTC INSPECTION .) Is a DTC displayed?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [360° VIEW MONITOR CONTROL MODULE (US)] .) (See DTC TABLE [VEHICLE CONTROL MODULE (US)] .)
2		No	If the front camera aiming is not completed correctly after performing the front camera aiming again, replace the 360° view monitor control module. (See 360° VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION [ (US)] .)