Selection of Procedure for 360° View Monitor System Aiming

NOTE:

For the front camera aiming, side camera aiming, and rear mount camera aiming, 1 set (1 set/2 targets) of the SST (49 JP04 001) are required.
For the 360° view monitor system aiming (batch aiming), 4 sets (1 set/2 targets) of the SST (49 JP04 001) are required. If 4 sets of the SST (49 JP04 001) is unavailable, perform the aiming for the 4 cameras individually.
When any of the following operations is performed, it is necessary to verify if the front camera aiming, side camera aiming, and rear mount camera aiming needs to be performed.
- Servicing requiring verification of necessity to perform front camera aiming
  - Front camera removal/installation
  - Front bumper removal/installation
- Servicing requiring verification of necessity to perform side camera aiming
  - Side camera removal/installation
  - Power outer mirror removal/installation
  - Lower outer mirror garnish removal/installation
  - Side turn light removal/installation
  - Front door removal/installation or adjustment
- Servicing requiring verification of necessity to perform rear mount camera aiming
  - Rear mount camera removal/installation
  - Rear bumper removal/installation

360° VIEW MONITOR SYSTEM AIMING DIAGNOSTIC PROCEDURE

Step	Procedure		Action after procedure
1	Was the 360° view monitor control module replaced?	Yes	Go to step 4.
1	Was the 360° view monitor control module replaced?	No	Go to the next step.
2	To determine if aiming is necessary or not, perform the 360° view monitor system screen display verification procedure. (See 360° VIEW MONITOR SYSTEM SCREEN DISPLAY VERIFICATION PROCEDURE ) Is it necessary to perform aiming?	Yes	Go to the next step.
2		No	Procedure is completed.
3	Which of the cameras requires aiming?	Front camera	Perform the front camera aiming and go to step 5. (See FRONT CAMERA AIMING PROCEDURE )
		Side camera	Perform the side camera aiming and go to step 5. (See SIDE CAMERA AIMING PROCEDURE )
		Rear mount camera	Perform the rear mount camera aiming and go to step 5. (See REAR MOUNT CAMERA AIMING PROCEDURE )
4	For the 360° view monitor system aiming (batch aiming), 4 sets of the SST (49 JP04001) are required. Are 4 sets of the SST (49 JP04 001) available?	Yes	Perform the 360° view monitor system aiming (batch aiming) procedure and go to step 5. (See 360° VIEW MONITOR SYSTEM AIMING (BATCH AIMING) PROCEDURE )
4		No	Individually perform aiming for the camera requiring aiming, then go to Step 5. (See FRONT CAMERA AIMING PROCEDURE ) (See SIDE CAMERA AIMING PROCEDURE ) (See REAR MOUNT CAMERA AIMING PROCEDURE )
5	Perform the 360° view monitor system screen display verification procedure. (See 360° VIEW MONITOR SYSTEM SCREEN DISPLAY VERIFICATION PROCEDURE ) Is 360° view monitor system aiming procedure needed?	Yes	Repeat Step 4.
5		No	Procedure is completed.