Action for Non-repeatable Malfunction

If the malfunction does not recur, verify the malfunction cause by performing the following actions:
- Verify that a DTC has been recorded in the memory. (See DTC INSPECTION (BLIND SPOT MONITORING (BSM) CONTROL MODULE) .)
- Based on the repair order form, attempt to drive the vehicle or perform tests to replicate the malfunction, record the data at that time, and detect the malfunction cause.
- Shake the wiring harness or connector of the electrical component which is suspected to be the cause of the malfunction, and inspect for occurrence of any malfunction or DTCs.
  
  Fig 1: Shaking Wiring Harness Or Connector Of Electrical Component
  Courtesy of MAZDA MOTORS CORP.
- Inspect the female terminals on the connector of the electric component which is suspected to be the cause of the malfunction for poor connection. (See ELECTRICAL SYSTEM .)
  NOTE:
  - Tool used (Reference): terminal test kit (49US-15-KIT)
  Fig 2: Inspecting Female Terminals On Connector Of Electric Component
  Courtesy of MAZDA MOTORS CORP.