Diagnostic Procedure

DTC U0443:00 RADAR UNIT DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	PERFORM DTC INSPECTION FOR REAR BODY CONTROL MODULE (RBCM) Perform the rear body control module (RBCM) DTC inspection using the M-MDS. (See DTC INSPECTION [REAR BODY CONTROL MODULE (RBCM)] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [REAR BODY CONTROL MODULE (RBCM)] .) Go to Step 4.
1		No	Go to the next step.
2	PERFORM DTC INSPECTION FOR INSTRUMENT CLUSTER Perform the instrument cluster DTC inspection using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) Go to Step 4.
2		No	Go to the next step.
3	VERIFY IF MALFUNCTIONING LOCATION IS REAR BODY CONTROL MODULE (RBCM) DEPENDING ON REPEATABILITY Clear radar unit DTCs using the M-MDS. (See CLEARING DTC (RADAR UNIT) .) Switch the ignition ON (engine on). Perform the radar unit DTC inspection using the M-MDS. (See DTC INSPECTION (RADAR UNIT) .) Is the same Pending DTC present?	Yes	Replace the rear body control module (RBCM), then go to the next step. (See REAR BODY CONTROL MODULE (RBCM) REMOVAL/INSTALLATION .)
3		No	Go to Step 5.
4	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear radar unit DTCs using the M-MDS. (See CLEARING DTC (RADAR UNIT) .) Switch the ignition ON (engine on). Perform the radar unit DTC inspection using the M-MDS. (See DTC INSPECTION (RADAR UNIT) .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction does not recur, go to the next step. If the malfunction recurs, replace the radar unit. (See RADAR UNIT REMOVAL/INSTALLATION .) Go to the next step.
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCs ARE PRESENT Verify other DTCs displayed. Are any other DTCs output?	Yes	Perform the corresponding DTC inspection.
5		No	DTC troubleshooting completed.