Diagnostic Procedure
DTC U2300:54 (POWER LIFTGATE CONTROL MODULE) DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | VERIFY IF OTHER DTCs DISPLAYED FOR POWER LIFTGATE (PLUG) CONTROL MODULE
|
Yes | Replace the power liftgate (PLUG) control module, then go to step 4. (See POWER LIFTGATE (PLUG) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 2 | VERIFY INSTRUMENT CLUSTER DTCs
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | Go to the next step. | ||
| 3 | RESET INSTRUMENT CLUSTER CONFIGURATION DATA
|
Yes | Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) |
| No | Go to Step 5. | ||
| 4 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the power liftgate (PLUG) control module, then go to the next step. (See POWER LIFTGATE (PLUG) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 5 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [POWER LIFTGATE (PLUG) CONTROL MODULE] .) |
| No | DTC troubleshooting completed. | ||