Diagnostic Procedure
DTC B1D01:13 [ADAPTIVE FRONT LIGHTING SYSTEM (AFS) CONTROL MODULE] DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | INSPECT FRONT COMBINATION LIGHT (RH) CONNECTOR CONDITION
|
Yes | Go to the next step. |
| No | Repair or replace the connector, then go to Step 6. | ||
| 2 | INSPECT ADAPTIVE FRONT LIGHTING SYSTEM (AFS) CONTROL MODULE CONNECTOR CONDITION
|
Yes | Go to the next step. |
| No | Repair or replace the connector, then go to Step 6. | ||
| 3 | INSPECT HEADLIGHT (RH) MALFUNCTION DETECTION CIRCUIT FOR SHORT TO GROUND
|
Yes | Refer to the wiring diagram and verify whether or not there is a common connector between adaptive front lighting system (AFS) control module terminal H and front combination light (RH) terminal N. If there is a common connector:
If there is no common connector:
Go to Step 6. |
| No | Go to the next step. | ||
| 4 | INSPECT HEADLIGHT (RH) MALFUNCTION DETECTION CIRCUIT FOR OPEN CIRCUIT
|
Yes | Go to the next step. |
| No | Refer to the wiring diagram and verify whether or not there is a common connector between adaptive front lighting system (AFS) control module terminal H and front combination light (RH) terminal N. If there is a common connector:
If there is no common connector:
Go to Step 6. |
||
| 5 | VERIFY IF MALFUNCTIONING LOCATION IS FRONT COMBINATION LIGHT (RH) DEPENDING ON REPEATABILITY
|
Yes | Replace the front combination light (RH), then go to the next step. (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION .) |
| No | Go to Step 7. | ||
| 6 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Repeat the inspection from Step 1.
Go to the next step. |
| No | Go to the next step. | ||
| Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. | |||
| 7 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | (See DTC TABLE [ADAPTIVE FRONT LIGHTING SYSTEM (AFS) CONTROL MODULE] .) |
| No | DTC troubleshooting completed. | ||