Diagnostic Procedure

DTC U2300:56 (AUTO LEVELING CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY INSTRUMENT CLUSTER DTCs Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the DTC displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .)
1		No	Go to the next step.
2	RESET INSTRUMENT CLUSTER CONFIGURATION DATA Using the M-MDS, perform the instrument cluster configuration with the As-Built data. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .) Clear the auto leveling control module DTCs using the M-MDS. (See CLEARING DTC [AUTO LEVELING CONTROL MODULE] .) Switch the ignition ON (engine off or on) and wait for 30 s or more. Retrieve the auto leveling control module DTCs using the M-MDS. (See DTC INSPECTION [AUTO LEVELING CONTROL MODULE] .) Is the same DTC displayed?	Yes	Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA) .)
2		No	Go to Step 4.
3	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the auto leveling control module DTCs using the M-MDS. (See CLEARING DTC [AUTO LEVELING CONTROL MODULE] .) Switch the ignition ON (engine off or on) and wait for 30 s or more. Retrieve the auto leveling control module DTCs using the M-MDS. (See DTC INSPECTION [AUTO LEVELING CONTROL MODULE] .) Is the same DTC displayed?	Yes	Replace the auto leveling control module, then go to the next step. (See AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [AUTO LEVELING CONTROL MODULE] .)
4		No	DTC troubleshooting completed.