DTC P0471-00: Exhaust Gas Pressure Sensor Circuit Range/Performance Problem: Notes
DTC P0471:00 (PCM, SKYACTIV-G 2.5T) DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P0471:00 |
Exhaust gas pressure sensor circuit range/performance problem |
| DETECTION CONDITION |
- Any one of the following conditions is met:
- The condition has continued for 2 s in which difference in barometric pressure measured and exhaust pressure is more than 25.8 kPa {0.263 kgf/cm2
, 3.74 psi}, difference in manifold absolute pressure and exhaust pressure is more than 30.7 kPa {0.313 kgf/cm2
, 4.45 psi} and difference in turbocharger/supercharger boost pressure and exhaust pressure is more than 30.7 kPa {0.313 kgf/cm2
, 4.45 psi}.
- The condition has continued for 2 s in which difference in barometric pressure measured and exhaust pressure is less than -25.8 kPa {-0.263 kgf/cm2
, - 3.74 psi}, difference in manifold absolute pressure and exhaust pressure is less than -30.7 kPa {-0.313 kgf/cm2
, -4.45 psi} and difference in turbocharger/supercharger boost pressure and exhaust pressure is less than - 30.7 kPa {-0.313 kgf/cm2
, -4.45 psi}.
MONITORING CONDITIONS
- Period vehicle being left: 6 h or more
- Battery voltage: 8 V or more
- Within 20 s after engine start
- The following DTCs are not detected:
- MAP sensor: P0107:00, P0108:00
- Boost pressure sensor: P0237:00, P0238:00
- Exhaust gas pressure sensor: P0472:00, P0473:00
- BARO sensor: P2228:00, P2229:00
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
- FREEZE FRAME DATA/Snapshot data is available.
- DTC is stored in the PCM memory.
|
| FAIL-SAFE FUNCTION |
- Inhibits the EGR control.
|
| POSSIBLE CAUSE |
- Exhaust gas pressure sensor connector or terminals malfunction
- Exhaust gas pressure sensor malfunction
- PCM connector or terminals malfunction
- PCM malfunction
|
| SYSTEM WIRING DIAGRAM |
|