Diagnostic Procedure
DTC U2005:68 - SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM) DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | VERIFY SAS CONTROL MODULE DTCs AGAIN
|
Yes | Go to the next step. |
| No | Go to Step 5. | ||
| 2 | VERIFY PCM DTCs
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (SKYACTIV-G 2.5T)] .) |
| No | Go to the next step. | ||
| 3 | PERFORM DTC INSPECTION AND VERIFY IF MALFUNCTIONING PART IS PCM
|
Yes | Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5T] .) |
| No | Go to Step 5. | ||
| 4 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the SAS control module, then go to the next step. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM] .) |
| No | Go to the next step. | ||
| 5 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [SAS CONTROL MODULE (STANDARD DEPLOYMENT CONTROL SYSTEM)] .) |
| No | DTC troubleshooting completed. | ||