Diagnostic procedure

DTC P188A:00 (ELECTRONIC AWD CONTROL SYSTEM) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	ALLOW VEHICLE TO COOL DOWN Switch the ignition OFF and allow the vehicle to cool down.		Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the AWD control module. (See CLEARING DTC [ELECTRONIC AWD CONTROL SYSTEM] .) Using the M-MDS, perform the AWD control module DTC inspection. (See DTC INSPECTION [ELECTRONIC AWD CONTROL SYSTEM] .) Is the same DTC present?	Yes	Replace the AWD control module, then go to the next step. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ELECTRONIC AWD CONTROL SYSTEM] .)
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.