Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial setting is reset, and auto up/down operation are disabled. Therefore, performing the initial setting is necessary.
- Door-electrical supply unit is replaced.
- Inching operation is performed 10 times using power window main switch or power window subswitch.
- Door glass is removed.
- Switch the ignition ON (engine on or off).
- Press the power window main switch or power window subswitch to fully open the door glass.
- Pull up the power window main switch or power window subswitch to the manual-up position to fully close the door glass and keep holding the switch up at the position for approx. 2 s.