DTC U2100-00: Start Stop Unit Configuration Not Completed (Start Stop Unit): Notes
DTC U2100:00 (START STOP UNIT) DETECTION CONDITION AND POSSIBLE CAUSE
| Description |
Start stop unit configuration not completed |
| Detection condition |
- Start stop unit configuration not completed.
|
| Fail-safe |
- Although the engine cannot be started with the ignition switched off or to ACC, if the ignition is switched ON (engine off), the engine can be started.
NOTE:
- If the start stop unit configuration is not completed, the start stop unit setting will be for an ATX vehicle.
- For MTX vehicles, if the start stop unit cannot receive the CAN signal, the engine cannot be started because the vehicle cannot be recognized as a MTX vehicle.
|
| Possible cause |
NOTE:
- This DTC is output if configuration is not performed after replacing the start stop unit.
- Start stop unit configuration error
- Start stop unit malfunction
|
| System wiring diagram |
Not applicable |