LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2020 >> CX-3 AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> On-Board Diagnostic - Blind Spot Monitoring Control Module >> DTC U0028-87: Blind Spot Monitoring (BSM) Control Module (LH) And (RH) Communication Error (Blind Spot Monitoring System) >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC U0028-87: Blind Spot Monitoring (BSM) Control Module (LH) And (RH) Communication Error (Blind Spot Monitoring System): Notes

CAUTION:
  • When replacing a blind spot monitoring (BSM) control module (RH) having any of the following part numbers, it is necessary to replace the blind spot monitoring (BSM) control module (LH) at the same time to perform the configuration normally.
    • DB2R-67Y80
    • DB2R-67Y80 A
DTC U0028:87 (BLIND SPOT MONITORING SYSTEM) DETECTION CONDITION AND POSSIBLE CAUSE

Description Blind spot monitoring (BSM) control module (LH) and (RH) communication error
Detection condition
  • No communication between blind spot monitoring (BSM) control modules (LH) and (RH) for 1 s or more with the ignition switched ON (engine off or on).
Fail-safe
  • Blind spot monitoring (BSM) system is stopped.
Possible cause
  • Blind spot monitoring (BSM) control module (RH) connector or terminal malfunction
  • Blind spot monitoring (BSM) control module (LH) connector or terminal malfunction
  • Short to ground in wiring harness between the following terminals:
    • Blind spot monitoring (BSM) control module (LH) terminal G-Blind spot monitoring (BSM) control module (RH) terminal G
      • Blind spot monitoring (BSM) control module (LH) terminal J-Blind spot monitoring (BSM) control module (RH) terminal J
  • Short to power supply in wiring harness between the following terminals:
    • Blind spot monitoring (BSM) control module (LH) terminal G-Blind spot monitoring (BSM) control module (RH) terminal G
      • Blind spot monitoring (BSM) control module (LH) terminal J-Blind spot monitoring (BSM) control module (RH) terminal J
  • Open circuit in wiring harness between the following terminals:
    • Blind spot monitoring (BSM) control module (LH) terminal G-Blind spot monitoring (BSM) control module (RH) terminal G
      • Blind spot monitoring (BSM) control module (LH) terminal J-Blind spot monitoring (BSM) control module (RH) terminal J
  • Blind spot monitoring (BSM) control module (RH) malfunction
  • Blind spot monitoring (BSM) control module (LH) malfunction
G13153843Courtesy of MAZDA MOTORS CORP.