Function Inspection Using M-MDS

DIAGNOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

Step	Inspection	Results	Action
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA Is the DTC P050A:00 on freeze frame data?	Yes	Go to the next step.
2		No	Go to the troubleshooting procedure for DTC on freeze frame data. (See DTC TABLE [PCM (VINs 7, L, M) (US)] .)
3	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
4	PURPOSE: INSPECT FOR OTHER RELATED DTCs Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (VINs 7, L, M) (US)] .)
4		No	Go to the next step.
5	PURPOSE: VERIFICATION IF MALFUNCTION CAUSED BY THROTTLE VALVE Switch the ignition ON (engine off). Access the THRO_ANG_ACT PID using the M-MDS. (See PID/DATA MONITOR INSPECTION .) While gradually depressing the accelerator pedal, verify that PID monitor THRO_ANG_ACT value increases. Does the monitor value change according to the amount the accelerator pedal is depressed?	Yes	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
5		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 2.