DTC Inspection [AWD Control Module]: Notes

Connect the M-MDS to the DLC-2.
After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
1. Select "Self Test".
2. Select "Modules".
3. Select "4x4".
Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See DTC TABLE [AWD CONTROL MODULE] .)
  NOTE:
  - Snapshot data appears at the top of the help screen when the displayed DTC is selected.
  - Snapshot data stores the currently detected DTC data.
After completion of repairs, clear all DTCs stored in the module. (See CLEARING DTC [AWD CONTROL MODULE] .)
NOTE:
- The AWD control module stores the following two types of information when a DTC is detected and displays snapshot data in the M-MDS
  - Vehicle information detected by AWD control module
  - Vehicle information detected by instrument cluster and received via CAN communication
- Refer to PID monitor table for confirm the AWD control module system operation status while the AWD control module does not store the DTC. (See PID/DATA MONITOR TABLE [AWD CONTROL MODULE] .)
- Snapshot data items are not displayed, according to detected DTC.