Transfer Removal/Installation [C66MX-R]: Notes

WARNING: This page is about a different variant/trim than selected.

Replacement Part

Oil seal	Oil seal
Quantity: 1	Quantity: 1
Location of use: Transfer oil seal (RH) No. 1	Location of use: Transfer oil seal (RH) No. 3

CAUTION:

Performing the following procedures could cause an open circuit in the front ABS wheel speed-sensor wiring harness if it is pulled by mistake. Before servicing, disconnect the front ABS wheel-speed sensor and set it aside so that the wiring harness will not be pulled by mistake.

Disconnect the negative battery terminal and wait for 1 min or more.
Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
Remove the propeller shaft.
Disconnect the ground plate. (See GROUND PLATE DISCONNECTION/CONNECTION .)
Remove the front crossmember component.
Remove the front drive shaft (RH).
Remove the bracket

Fig 1: Bracket Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove the heat shield.

Fig 2: Heat Shield Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
f.

Fig 3: Transfer Bracket Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Drain the transfer oil. (See TRANSFER OIL REPLACEMENT [C66MX-R] .)
Remove in the order shown in the figure.
Install in the reverse order of removal.
After the engine and transaxle warms up, inspect for oil leakage and transfer operation.

Fig 4: Transfer Components With Torque Specification
Courtesy of MAZDA MOTORS CORP.

PART DESCRIPTION

Component no.	Refer to
1	Transfer oil seal (RH) No. 1 (See TRANSFER OIL SEAL REPLACEMENT [C66MX-R] .)
2	Transfer oil seal (RH) No. 3 (See TRANSFER OIL SEAL REPLACEMENT [C66MX-R] .)
3	Transfer