On-Board Diagnostic - Auto Leveling Control Module
- Active Command Modes Table [Auto Leveling Control Module]
- DTC C0061-54: Auto Leveling Control Module Detects That The Acceleration Sensor Initial Position Learning Is Not Completed [AUTO LEVELING CONTROL MODULE]
- DTC C0061-96: Auto Leveling Control Module Cannot Receive The Signal From The Acceleration Sensor [AUTO LEVELING CONTROL MODULE]
- DTC Table [Auto Leveling Control Module (Us)]
- DTC U0001-88: Auto Leveling Control Module Detected CAN BUS Communication Line (CAN) Malfunction 10 Times Continuously [AUTO LEVELING CONTROL MODULE]
- DTC U0122-87: Auto Leveling Control Module Cannot Receive CAN Signal From The DSC HU/Control Module [AUTO LEVELING CONTROL MODULE (US)]
- DTC U0416-29: Auto Leveling Control Module Received Error Signal From The DSC HU/Control Module [AUTO LEVELING CONTROL MODULE (US)]
- DTC U0416-41: Auto Leveling Control Module Received Error Signal (Sum Error) From The DSC HU/Control Module [AUTO LEVELING CONTROL MODULE (US)]
- DTC U0416-82: Auto Leveling Control Module Received Error Signal (Counter Error) From The DSC HU/Control Module [AUTO LEVELING CONTROL MODULE (US)]
- DTC U212A-87: Auto Leveling Control Module Cannot Receive CAN Signal From The Light Control Module (LH) [AUTO LEVELING CONTROL MODULE]
- DTC U212B-87: Auto Leveling Control Module Cannot Receive CAN Signal From The Body Control Module (BCM) [AUTO LEVELING CONTROL MODULE]
- DTC U212D-87: Auto Leveling Control Module Cannot Receive CAN Signal From The Light Control Module (RH) [AUTO LEVELING CONTROL MODULE]
- DTC U2300-54: Auto Leveling Control Module Cannot Receive The Configuration Data From The Body Control Module (BCM) [AUTO LEVELING CONTROL MODULE]
- DTC U2300-55: Auto Leveling Control Module Received A Signal Which Indicates The Body Control Module (BCM) Configuration Is Not Performed [AUTO LEVELING CONTROL MODULE]
- DTC U2300-56: Configuration Data Of The Auto Leveling Control Module And Body Control Module (BCM) Are Not Matched [AUTO LEVELING CONTROL MODULE]
- DTC U250A-86: Auto Leveling Control Module Received Error Signal From The Light Control Module (LH) [AUTO LEVELING CONTROL MODULE]
- DTC U250D-86: Auto Leveling Control Module Received Error Signal From The Light Control Module (RH) [AUTO LEVELING CONTROL MODULE]
- DTC U3000-42: Auto Leveling Control Module Detects The Internal Malfunction [AUTO LEVELING CONTROL MODULE]
- DTC U3003-16: Auto Leveling Control Module Power Supply Circuit Voltage Is Lower Than The Standard [AUTO LEVELING CONTROL MODULE (US)]
- DTC U3003-17: Auto Leveling Control Module Power Supply Circuit Voltage Is Higher Than The Standard [AUTO LEVELING CONTROL MODULE (US)]
- Headlight Leveling Actuator Operation Check Mode [Auto Leveling Control Module]
- PID/Data Monitor Table [Auto Leveling Control Module]
- Snapshot Data Table [Auto Leveling Control Module]