LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2022 >> CX-5 S >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Basic System - HVAC >> Blower Fan Controller Inspection >> Notes
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Blower Fan Controller Inspection: Notes

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION ).
    2. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION ).
  3. Remove the blower fan controller. (See BLOWER FAN CONTROLLER REMOVAL/INSTALLATION ).
  4. Connect the blower fan controller connector.
  5. Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
  6. Switch the ignition ON (engine off or on).
  7. Connect the negative (-) lead of the tester to body ground.
  8. Insert the positive (+) lead of the tester into each blower fan controller terminal.
  9. Measure the voltage according to the terminal voltage table.
    • If there is any malfunction, inspect the parts under "Inspection item (s)".
    • If the parts under "Inspection item (s)" are found to be normal, replace the blower fan controller. (See BLOWER FAN CONTROLLER REMOVAL/INSTALLATION ).
    G12188017Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals