DTC U2300-55: Body Control Module (BCM) Configuration Not Implemented [Adaptive Led Headlights Control Module]: Outline
DTC U2300:55 (ADAPTIVE LED HEADLIGHTS CONTROL MODULE) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Body control module (BCM) configuration not implemented |
| Detection condition |
- The adaptive LED headlights control module received a signal which indicates the body control module (BCM) configuration is not performed.
|
| Fail-safe |
- Perform the following controls with the adaptive LED headlights turned on.
- Turn off glare-free high beam.
- Set wide-range low beam as basic light distribution.
- The headlight leveling actuator is stopped at the position when the malfunction is determined.
|
| Possible cause |
NOTE:
- To correctly write the configuration data sent from the body control module (BCM) to the adaptive LED headlights control module, 30 s or more have to be elapsed since the ignition is switched ON (engine off or on).
- Body control module (BCM) configuration is not completed.
- Body control module (BCM) malfunction
- Adaptive LED headlights control module malfunction
|
| System wiring diagram |
Not applicable |
| Connector diagram |
Not applicable |