Inspection/action procedure
- This DTC may be displayed due to the following DTC. If the following DTC is displayed, give priority to performing the inspection/action.
- Vehicle control module (VCM) (See DTC TABLE [VCM]
)
- DTC related to internal malfunction
- Body control module (BCM) (See DTC TABLE [BCM]
)
- DTC related to internal malfunction
- 360° view monitor control module/parking assist unit (optical) (See DTC TABLE [VMC] )
- Vehicle control module (VCM) (See DTC TABLE [VCM]
)
- Go to the inspection/action in the order from Step 1 below.
- After part repair or replacement, perform the repeatability verification procedure and perform a DTC inspection. (See DTC INSPECTION
)
- If the DTC inspection indicates the same DTC again, go to the next step.
- Perform the 360° view monitor system aiming.
Purpose/reason (possible cause) The 360°view monitor system aiming was not implemented. Referred to service information item See 360DEGREES VIEW MONITOR SYSTEM AIMING - Replace the 360° view monitor control module/parking assist unit (optical).
Purpose/reason (possible cause) 360° view monitor control module/parking assist unit (optical) malfunction (applicable part can not be inspected to determine integrity) Referred to service information item See 360DEGREES VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION .
See PARKING ASSIST UNIT (OPTICAL) REMOVAL/INSTALLATION . - Replace the body control module (BCM).
Purpose/reason (possible cause) Vehicle control module(VCM) malfunction (no other possible malfunction considered) Referred to service information item See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION