| 1 |
- Close all doors.
- Switch the ignition ON (engine off or on).
- In automatic mode, push down the power window main switch for the driver-side front door glass. The door glass should move down within approx. 40s after ignition switch off (LOCK).
- In manual mode (finger continuously depressing the power window main switch), the door glass should move down within approx. 40s after ignition switch off (LOCK).
- Does the driver-side front door glass move down?
|
Yes |
Go to the next step. |
| No |
- Perform the driver-side power window initialization procedure, and reinspect. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE
.)
- If it does not move up and down upon reinspection, inspect the following:
- Wiring harness for the door open/close signal system
- Latch switch
- Repair or replace the malfunctioning part, and reinspect.
- If operation is not normal, replace the power window main switch, and then go to the next step.
|
| 2 |
- Switch the ignition ON (engine off or on).
- In automatic mode, pull up the power window main switch and subswitch for the all doors glass. The door glass does not move up within approx. 40s after ignition switch off (LOCK).
- Verify that driver-side all doors glass does not operate.
- Does the driver-side all doors glass move up?
|
Yes |
- Perform the suspect power window initialization procedure, and reinspect. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE
.)
- If operation is not normal, replace the suspect power window switch, then go to the next step.
|
| No |
Go to the next step. |
| 3 |
- Switch the ignition ON (engine off or on).
- Perform the following for all doors.
- Lower the driver-side front door glass completely.
- Take a hammer and hold it against the inside of the top of the door glass frame so that the door glass will hit its handle when it is closing.
- Raise the door glass using manual mode.
- When the door glass hits the hammer handle, does it immediately reverse and move down to approx. 200 mm {7.87 in} from the completely closed position?
|
Yes |
Go to the next step. |
| No |
- Perform the suspect power window initialization procedure, and reinspect. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE
.)
- If operation is not normal, replace the suspect power window switch, then go to the next step.
|
| 4 |
- Open any door.
- Switch the ignition ON (engine off or on).
- Push/pull the power window main switch or subswitch for all door glass within approx. 40s after ignition switch off (LOCK).
- Verify that the door glass does not move up or down.
- Does the door glass move up or down?
|
Yes |
- Inspect the suspect door switch and related wiring harness.
- If above parts are normal, replace the suspect power window switch, then go to the next step.
- If the above parts have any malfunction, repair or replace the malfunction part, then go to the next step.
|
| No |
Go to the next step. |
| 5 |
- Close all doors.
- Switch the ignition ON (engine off or on).
- Push/pull the power window main switch or subswitch for all door glass after approx. 60s after ignition switch off (LOCK).
- Verify that the door glass does not move up or down.
- Does the door glass move up or down?
|
Yes |
|
| No |
The IG OFF timer function is normal. |