Diagnostic procedure

DTC P182F:00 (AWD CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	ALLOW VEHICLE TO COOL DOWN Switch the ignition off and allow the vehicle to cool down.	-	Go to the next step.
2	INSPECT TRANSFER FOR MALFUNCTION Shift the selector lever to the N position. Lift up the vehicle. Turn the propeller shaft and rotate the front wheels. Do the front wheels rotate smoothly?	Yes	Go to the next step.
2		No	Replace the transfer, then go to Step 4. (See TRANSFER REMOVAL/INSTALLATION [FW6AX-EL] ) (See TRANSFER REMOVAL/INSTALLATION [GW6AX-EL (VIN Y)] )
3	INSPECT COUPLING COMPONENT AND REAR DIFFERENTIAL FOR MALFUNCTION Shift the selector lever to the N position. Connect the M-MDS to the DLC-2. Switch the ignition ON (engine off). Access the following simulation item using the M-MDS: CUP_SOL Lift up the vehicle. Turn the simulation item CUP_SOL on and turn the AWD solenoid on. Turn the propeller shaft and rotate the rear wheels. Do the rear wheels rotate smoothly?	Yes	Go to the next step.
3		No	Repair or replace the malfunctioning location, then go to Step 4. (See COUPLING COMPONENT REMOVAL/INSTALLATION .) (See REAR DIFFERENTIAL REMOVAL/INSTALLATION .)
4	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See CLEARING DTC [AWD CONTROL MODULE] .) Using the M-MDS, perform the AWD control module DTC inspection. (See DTC INSPECTION [AWD CONTROL MODULE] .) Is the same Pending DTC present?	Yes	Replace the AWD control module. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [AWD CONTROL MODULE] .)
5		No	DTC troubleshooting completed.