Multi-function control module (CCM), function - GF54.21-P-0001F

MODEL 210 

Interlinkage of components 

15.2.96

Standardization note added

The multifunction control module (N10-1)  contains the following previously separate control modules

• Convenience control module (N57)
• Convenience relays (K24)
• Wiper system relays (K26, K26k1, K26k2, K26k3)
• Time function relay (K13)

It controls the following functions

• 4 power windows
• Outside mirror adjustment (only with driver memory)
• Tilting/sliding roof
• Interior lighting
• Exit lamps
• Central locking interior actuation switch (switch signal only)
• Turn signals
• Jacket tube memory
• Rear window defroster (switch signal only)
• Wiper system control
• Rear head restraints (switch signal only)
• Residual heat (switch signal only)
• Trunk lid remote control (switch signal only)

The multifunction control module (N10-1) can be coded for specific countries and specific models.

New control modules connected to battery voltage for the first time, must be programmed with the following data using the HHT:

The multifunction control module (N10-1) can be reprogrammed as often as desired, e.g. when equipment is retrofitted.

Coding

• / ECE
• 
• Right-hand steering/left-hand steering
• Model 210.0 (sedan)

  Model 210.2 (T-model)

Coding equipment

• ATA (including interior lighting with ATA alarm on/off)
• Driver's seat with memory
• Passenger seat with memory
• Rain sensor

On vehicles with left front seat memory each switching position for the outside rear view mirror as well as for the steering column must be actuated for ≥ 2 sec. with the appropriate control switch with the ignition ON after replacing the multifunction control module (N10-1) or interrupting the power.

Fault memory 

The fault memory for the multifunction pneumatic system equipment (A37) is integrated into the multifunction control module (N10-1).

The fault memory in the

• front left power seat control module with memory (N32/1),
• front right power seat module with memory (N32/2),
• ATA control module (is integrated into A37)

can be read out via the multifunction control module (N10-1). Each of these control modules has its own fault memory.

The fault memory can be read out only with the HHT.