September 30: LEMON manuals is back up on a temporary server! Slowness is possible
DTC Description
- Fault Memory & Actuation Of MIL -
After 2 consecutive driving cycles with fault.
- Frequency Of Testing -
Continuous.
- Checked Signal Or Status -
Limit values of oxygen sensor signal and sensor status change.
- Lower Limit Value -
Voltage must not be less than -0.15 volts.
- Upper Limit Value -
Voltage must not be greater than 1.5 volts.
- Duration Of Test -
Less than 5 seconds.
- Sensor Status Change -
After approximately 220 seconds with sensor heater switched on, the sensor signal must not dwell in the 0.4-0.6 volt window for more than approximately 15 seconds.
- Test Conditions -
Engine speed approximately 1000-2000 RPM, engine load approximately 15-50 percent, TWC temperature more than 572°F (300°C) and Lambda control enabled.