| 1 |
Close all doors, switch on ignition |
|
| 2 |
Set time on instrument cluster |
|
| 3 |
Switch low beam on and off |
|
| 4 |
Switch air conditioning on and off |
|
| 5 |
Switch rear air conditioning on and off |
If installed. |
| 6 |
Switch radio (COMAND) on and off |
If installed. |
| 7 |
Normalize all power windows |
Move each window all the way down and then all the way back up again. In this position, press each switch of the power window switch group for at least 3 s. |
| 8 |
Normalize the power glass tilting/sliding roof |
Only vehicles with power glass tilting/ sliding roof, code 414.
-
Open tilting/sliding roof all the way and close again, press and hold switch, after closing, for at least 3 s.
-
Operate express function by pressing the switch briefly (beyond point of resistance). If the tilting/sliding roof then fully opens, the normalization was successful. If necessary, repeat the procedure.
|
| 9 |
Normalize power pop-out windows |
If installed. |
| 10 |
Start engine |
|
| 11 |
Turn steering wheel to left stop, then turn it to right stop |
This normalizes the steering angle sensors. |
| 12 |
Switch off the engine and ignition |
|
| 13 |
Get out the vehicle, close driver door |
|
| 14 |
Lock and unlock vehicle |
|
| 15 |
Open and close driver door |
|
| 16 |
Calibrating the compass |
If installed.
-
Call up and run calibration via instrument cluster. Calibration is conducted by driving a complete circle at low speed.
-
Do not perform calibration in the vicinity of high-voltage lines or large structural steel work; switch off as many electrical consumers in the vehicle as possible.
|