Specifications Index
171 CHASSIS SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | CAPACITIES & SPECIFICATIONS | |
| Torque | See applicable components in TESTING & REPAIR | |
| Axle Nut/Hub Nut (Collar Nut) | ||
| Front | See applicable components in TESTING & REPAIR | |
| Rear | 220 Nm | |
| Battery | TESTING & REPAIR | |
| Brakes | ||
| Bleeding Sequence | RR, LR, RF, LF | |
| Disc Brakes | TEST & ADJUSTMENT VALUES | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | REMOVE/INSTALL ALTERNATOR | |
| Torque | REMOVE/INSTALL ALTERNATOR | |
| Drive Belts | ||
| Adjustment | TESTING & REPAIR | |
| Belt Routing | TESTING & REPAIR | |
| Engine Cooling | ||
| General Service Specifications | CAPACITIES & SPECIFICATIONS | |
| Radiator Cap Pressure | TEST & ADJUSTMENT VALUES | |
| Thermostat R & I | REMOVE/INSTALL COOLANT THERMOSTAT | |
| Water Pump R & I | REMOVE/INSTALL COOLANT PUMP | |
| Engine Mechanical | ||
| Compression | ENGINE, TECHNICAL DATA | |
| Oil pressure | N/A | |
| Overhaul | N/A | |
| Torque | See applicable components in COMPLETE ENGINE -- TESTING & REPAIR ............................................................................................ See applicable components in ENGINE TIMING -- TESTING & REPAIR ............................................................................................ See applicable components in CRANK ASSEMBLY -- TESTING & REPAIR |
|
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | REMOVE/INSTALL FLYWHEEL / DRIVE PLATE | |
| Fuel System | ||
| Fuel Filter Location | See illustration in REPLACE FUEL FILTER | |
| Fuel Filter R & I | REPLACE FUEL FILTER | |
| Pressure Release Procedure | A pressure gauge connection with valve is used for testing the fuel pressure and for releasing the pressure when carrying out assembly operations. See pressure gauge connection in the illustration provided in COMPONENT DESCRIPTION OF FUEL DISTRIBUTION RAIL . | |
| Pressure Specification | approx. 3.8 bar | |
| Fuel Pressure Test Procedure | A pressure gauge connection with valve is used for testing the fuel pressure and for releasing the pressure when carrying out assembly operations. See pressure gauge connection in the illustration provided in COMPONENT DESCRIPTION OF FUEL DISTRIBUTION RAIL | |
| Ignition | ||
| Firing Order | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Routing) | Coil on plug | |
| Spark Plug | ||
| Type | Bosch FR7KPP33U | |
| Gap | N/A | |
| Torque | 25 Nm | |
| Starting | ||
| Starter | REMOVE/INSTALL STARTER | |
| Torque | REMOVE/INSTALL STARTER | |
| Wheel Alignment | ||
| Adjustment Specifications | TEST & ADJUSTMENT VALUES | |
| Torque | See applicable components in TESTING & REPAIR | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 110 Nm | |