Service Campaign 2013110002 - Update Fuel System Control Module Software (2013110002)

Publication date: 2013-11-22
Reference number: 2013110002

SERVICE CAMPAIGN 2013110002 - UPDATE FUEL SYSTEM CONTROL MODULE SOFTWARE

SERVICE CAMPAIGN BULLETIN

Reference Number(s): 2013110002, Date of Issue: November, 2013

MERCEDES-BENZ:

Models 166, X166, 172, 204, X204, 207, 212, 216, 218, 221, 231, 251 Model Years 2011- 2013

SUBJECT

Models 166, X166, 172, 204, X204, 207, 212, 216, 218, 221, 231, 251 Model Years 2011- 2013

Update Fuel System Control Module Software

This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the fuel system control module software does not correspond to current production configuration. As a result a Check Engine Light (CEL) may occur. An authorized Mercedes-Benz dealer will update the fuel system control module software at the next workshop visit.

Prior to performing this Service Campaign:

Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Approximately 123,831 vehicles are affected.

PROCEDURE

NOTE:

Use DAS/Xentry 09-10/13 with add-on 3153 or higher.
Follow the steps exactly as described in DAS/Xentry.
Connect battery charger (battery voltage >12.5V).
Ensure all electrical consumers are switched-off.
In the event of software/SCN update issues, contact Star Diagnosis User Help Desk. Please refer to the "pre-call" check list before contacting UHD
Refer to Star Diagnosis System (SDS) Best Practices Guide.

Update fuel system control module software (FSCU):
- DAS: Control units/Drive/FSCU/Control unit adaptations/Control unit programming.
- Xentry: Control unit view/Drive type/FSCU/Fuel pump/Adaptations/Control unit programming.
Follow on-screen instructions.
NOTE: Please verify fuel system control module software number change after performing the software update.

NOTE: The following allowable labor operation should be used when submitting a warranty claim for this repair:

WARRANTY INFORMATION

Operation

Connect/disconnect battery charger (02-5058)
Star Diagnosis System (SDS), Connect/disconnect (02-4762)
Update fuel system control unit software (02-8323).

WARRANTY INFORMATION

Damage Code	Operation Number	Labor Time (hrs.)
54 981 43 8	02-5058	0.1
	02-4762	0.1
	02-8323	0.1

NOTE: Operation Number labor times are subject to change.