Service Campaign 2014060004 - SCN Code The Headlamp Control Module (2014060004)

Publication date: 2014-07-03
Reference number: 2014060004

SERVICE CAMPAIGN 2014060004 - SCN CODE THE HEADLAMP CONTROL MODULE

SERVICE CAMPAIGN BULLETIN

Reference Number(s): 2014060004, Date of Issue: July 3, 2014

MERCEDES-BENZ:

Model 216, Model Year 2014

SUBJECT

Model 216, Model Year 2014

SCN Code the Headlamp Control Module

This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the SCN coding in the headlamp control module does not correspond to current series production and as a result the spotlight function may not be available. To correct this condition an authorized Mercedes-Benz dealer will SCN code the headlamp control module at the next workshop visit.

Prior to performing this Service Campaign:

Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Approximately 214 vehicles are affected.

PROCEDURE

NOTE:

Use DAS/Xentry 05-06/14 with all associated patches or higher.
Follow the steps exactly as described in DAS/Xentry.
Connect battery charger (battery voltage >12.5V).
Ensure all electrical consumers are switched-off.
In the event of software/SCN update issues, contact Star Diagnosis User Help Desk. Please refer to the "pre-call" check list before contacting UHD
Refer to Star Diagnosis System (SDS) Best Practices Guide.

Perform SCN coding in XALWA control unit:
Control units/Body/XALWA xenon headlamps/Control unit adaptations/SCN coding.
Follow on-screen instructions.
NOTE: The following allowable labor operation should be used when submitting a warranty claim for this repair:

WARRANTY INFORMATION

Operation

Connect/disconnect battery charger (02-5058)
Star Diagnosis System (SDS), Connect/disconnect (02-4762)
Perform SCN coding in headlamp control module (02-8558)

WARRANTY INFORMATION

Damage Code	Operation Number	Labor Time (hrs.)
54 982 44 8	02-5058	0.1
	02-4762	0.1
	02-8558	0.1

NOTE: Operation Number labor times are subject to change.